Which IOS commands should you enter in interface configuration mode to configure a switch port as an access port and assign it to VLAN 25? (Choose two.)

Last Updated on August 1, 2021 by Admin 2

Which IOS commands should you enter in interface configuration mode to configure a switch port as an access port and assign it to VLAN 25? (Choose two.)

  • trunk on
  • switchport mode access
  • vlan-membership static 25
  • switchport access vlan 25
Explanation:

Use the following steps to assign ports to a VLAN:

1. Enter the interface to be added to the VLAN.
switch(config)# interface interface-id
2. Configure the port as a Layer 2 access port.
switch(config-if)# switchport mode access
3. Assign the port to a VLAN.
<fon

Objective:
Layer 2 Technologies
Sub-Objective:
Configure and verify VLANs

0 0 votes
Article Rating
Subscribe
Notify of
guest
0 Comments
Inline Feedbacks
View all comments