Last Updated on August 6, 2021 by Admin 3
On which of the following interfaces can a port ACL be applied? (Select 3 choices.)
- an SVI
- a trunk port
- an EtherChannel interface
- a routed port
- a Layer 2 port
Explanation:
A port access control list (PACL) can be applied to a trunk port, a Layer 2 port, or an EtherChannel interface. PACLs filter inbound Layer 2 traffic on a switch port interface; PACLs cannot filter outbound traffic. When PACLs are applied on a switch, packets are filtered based on several criteria, including IP addresses, port numbers, or upperlayer protocol information. If a PACL is applied to a trunk port, it will filter all virtual LAN (VLAN) traffic traversing the trunk, including voice and data VLAN traffic. A PACL can be used with an EtherChannel configuration, but the PACL must be applied to the logical EtherChannel interface? physical ports within the EtherChannel group cannot have a PACL applied to them.
PACLs cannot be applied to a switch virtual interface (SVI) or to a routed port. An SVI is a virtual interface that is used as a gateway on a multilayer switch. SVIs can be used to route traffic across Layer 3 interfaces. However, PACLs can only be applied to Layer 2 switching interfaces. Furthermore, because PACLs operate at Layer 2, they cannot be applied to routed ports, which operate at Layer 3.
A port access control list (PACL) can be applied to a trunk port, a Layer 2 port, or an EtherChannel interface. PACLs filter inbound Layer 2 traffic on a switch port interface; PACLs cannot filter outbound traffic. When PACLs are applied on a switch, packets are filtered based on several criteria, including IP addresses, port numbers, or upperlayer protocol information. If a PACL is applied to a trunk port, it will filter all virtual LAN (VLAN) traffic traversing the trunk, including voice and data VLAN traffic. A PACL can be used with an EtherChannel configuration, but the PACL must be applied to the logical EtherChannel interface? physical ports within the EtherChannel group cannot have a PACL applied to them.
PACLs cannot be applied to a switch virtual interface (SVI) or to a routed port. An SVI is a virtual interface that is used as a gateway on a multilayer switch. SVIs can be used to route traffic across Layer 3 interfaces. However, PACLs can only be applied to Layer 2 switching interfaces. Furthermore, because PACLs operate at Layer 2, they cannot be applied to routed ports, which operate at Layer 3.
Subscribe
Login
0 Comments