Consider the following diagram. All PVCs are active.

Last Updated on August 1, 2021 by Admin 1

Consider the following diagram. All PVCs are active.

300-410 Part 07 Q16 091
300-410 Part 07 Q16 091

If the partial output of the show ip ospf neighbor command executed on Router A is as follows, which of the following statements is TRUE?

RouterA# show ip ospf neighbor

Neighbor ID Pri State Dead Time Address Interface
1.1.1.1 1 FULL/DROTHER 00:00:13 10.20.10.21 SerialO
2.2.2.2 1 FULL/DR 00:00:51 10.20.10.22 SerialO

  • Router C and Router B will fail to have all OSPF routes in their tables.
  • All routing tables will be populated correctly.
  • Router A will be the DR.
  • Router C will be the DR.
Explanation:
The output of the command shows that Router C and Router B will fail to have all OSPF routes in their tables. In a hub and spoke configuration, as depicted in the diagram, the hub router (Router A) should be the designated router (DR) or the source of updates to the other routers. However, Router B is the DR, as evidenced by the output of the show ip ospf neighbor command executed on Router A.

This situation could be rectified by setting Routers B and C with a priority of 0, which would disqualify them from being the DR. After that, all routes could be distributed from the hub, which would have visibility of all routes.

All routing tables will be populated correctly until the hub router is made the DR.

Neither Router A nor C will be the DR, since it is indicated that Router B is the DR in the output of the command.

Objective:
Layer 3 Technologies
Sub-Objective:
Configure and verify OSPF operations

0 0 votes
Article Rating
Subscribe
Notify of
guest
0 Comments
Inline Feedbacks
View all comments